Re: A Tale of Two Patricians

Posted by humanpotatohybrid On 2022/3/19 20:20:06
Quote:

PackardDon wrote:
It occurred to me that perhaps when I installed the tumbler, the post on the bottom missed the hole it should have gone into inside the switch.


I suppose that is possible but I personally find it unlikely. I would take the tumbler out of both your rebuilt and original switches: check that the grooves in the outer cylinder (the housing) are the same on both relative to the starter bezel indexing pegs. I suspect that your new one is 45deg off.

And while you're at it, you may as well check that the core was inserted into the switching plate in the back properly.

This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=242006