Re: Saving the original paintwork and trunk emblem - 1951 200 barn findand

Posted by BDeB On 2019/6/22 16:43:12
Quote:

PackardDon wrote:
As I recall, you have to disconnect the connector from below the gearbox under the hood, then pull the wire out through the column. The other end has a bullet-type connector that should be able to slip through the washers.


And if you tie a piece of sting to the lower end of the wire before pulling it out you can untie to remove the steering wheel and then use the string to pull the wire back through the steering column.

This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=212762