Re: '38 1608 V12 Project
Posted by blue40devil On 2020/12/17 11:43:21
Lightly touched up the valve seats.
Machined a bushing to allow me the ability to cut them without having to put the guides back in and use a pilot that I already had.
Took less than a turn to get them bright.
I will lap and set the clearance on the valves once the guides are in, but you have to have the silencer blocks installed to do that
Attach file:
(161.18 KB)
Machined a bushing to allow me the ability to cut them without having to put the guides back in and use a pilot that I already had.
Took less than a turn to get them bright.
I will lap and set the clearance on the valves once the guides are in, but you have to have the silencer blocks installed to do that
Attach file:
(161.18 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=228900