Re: Vacation Car - 56 Patrician
Posted by CarFreak On 2020/7/13 9:48:06
Quote:
Let the ride decide wrote:
On the factory A/C vents,
Would the blueprints be helpful with a 3D printer, or do you need the part to use with a 3D printer?
Let the Ride Decide:
Depending on the detail of the prints the blue prints would actually be better. The blue prints should have the tolerances that the factory says it should have while any physical part that could be used for 3D printing could not only be out of factory specification, but could be damaged, modified or simply just warped/shrunk due to age and sunlight.
From the blue prints a 3D model could be created in the computer and then 3D printed.
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=224613