Re: PackardDon's 1956 Clipper Custom Sedan
Posted by HH56 On 2020/7/9 13:19:28
It is notched. You can buy a commercial tool used on GM products from some parts stores or ebay that work reasonably well.
The notch on the tool is slightly larger than the Packard shaft so it takes a bit of finesse to get both sides of the clip to release at the same time but is workable.
Attach file:
(34.59 KB)
The notch on the tool is slightly larger than the Packard shaft so it takes a bit of finesse to get both sides of the clip to release at the same time but is workable.
Attach file:
(34.59 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=224440