Re: Resurrecting a 1951 Henney-Packard Parts Car

Posted by Packard Don On 2020/6/16 18:42:54

Update: It seems that most exhaust system makers are unable to make this pipe because it has many small bends that are relatively close together. These shops apparently use a mandrel bender so I need to find one that can do 3-roller bending. I wrote to one in Clackamas, OR but no reply yet. Of the 16+ shops I contacted, there were three or four that never replied and those that did said no other than one who has said they are studying it and will get back to me.