Re: Resurrecting a 1951 Henney-Packard Parts Car
Posted by Packard Don On 2020/7/3 21:29:01
In an effort to clean up a bit and not have unnecessary things sitting around (yes, I'm dreaming!), I decided to take off the old rusty and unusable brake drum and replace it with the new one that arrived just as I was closing up shop in March when I was last there. Even though I had put on the rusty one only hand tight not too long ago, I had to resort to the puller to get it off again! It took only couple light taps, though, and it was off.
Looking back at photos from a couple months ago I see that I have to replace the backing plate on this side too which I had forgotten about. The one on the rear end is also rusty to match the drum and I have a good one already.
Attach file:
(310.16 KB)
(327.13 KB)
Looking back at photos from a couple months ago I see that I have to replace the backing plate on this side too which I had forgotten about. The one on the rear end is also rusty to match the drum and I have a good one already.
Attach file:
(310.16 KB)
(327.13 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=224212