Re: Resurrecting a 1951 Henney-Packard Parts Car

Posted by Packard Don On 2020/7/4 14:06:05

That appears to be it! Since it fits only 1951-1954 Henney, I guess I'll have to make (or have made) some myself. The one on the side shown above was very, very brittle and appeared to have the keyway tang in 3D - that is, it appeared to be a block off of the surface rather than flat so perhaps it was made long, then tucked down into the keyway where it hardened. Odd this is not shown on the axle view which shows all other gaskets and seals!