Re: KPack's 1954 Panama

Posted by kevinpackard On 2021/1/8 0:13:03

Well that was a nice easy job. Ross was right...though it took me closer to 10 seconds. 1/4" drill bit straight down. Really easy to tell if you're drilling the steel or touching the iron. Going to grab a piece of tubing from NAPA tomorrow, then bend, cut and install. Waiting for a replacement choke thermostat (replacement carb's choke thermostat housing is falling apart) then the new carb goes on.

Thanks for the help!

Attach file:

---

  (122.72 KB)