Thanks Kev! Slowly but surely getting there.
I had some window run channel samples come in from Rubber the Right Way today. It looks like the piece they have for the front channel (behind the vent window) will work. It has stainless beads, whereas the original does not. But the size is right and should drop right once I remove the original channel. Just not sure about the bead or not.
The sample for the rear channel does not fit in the metal frame. It is too wide. But the inside dimension is correct for the rear of the window frame....it's 1/8", which is enough or the stainless window frame to glide in.
I tried a generic channel out of curiosity. It doesn't fit that well, but technically it does work. But I'd like to have it close to original if possible.
Does anyone have a part number they used for run channel from Restoration Specialities?
-Kevin
Attach file:
Beaded run channel.jpg (87.84 KB)
Beaded run channel 2.jpg (81.84 KB)
Rear run channel incorrect size.jpg (76.97 KB)
Rear channel possible solution.jpg (89.07 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=254455