Did a small project the other day. The headlight rings on my parts car were nearly perfect so I wanted to switch them out. The rings that came on the Panama weren't terrible, but they had some pitting:
The upper tabs were missing from both of the donor headlight rings. I found a tab from one of the original rings in the box of random pieces that came in the trunk of the Panama. I used that as a pattern to make another tab from a stainless steel bracket:
Then I glued the tab I made and the old tab onto the new rings with JB Weld:
After letting it cure overnight I popped both the rings on with no issue. They are rock solid and should do fine. I'm not sure if the JB Weld will hold up if I have to take them back off, but at least for now they are working.
![Original Image](https://packardinfo.com/xoops/html/uploads/newbb/1059phpD7t10J_sm.jpg)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=270107