Posted by HH56 on 2020/10/26 21:01:41
On 55-6 models the manual brake master was bolted to the center X frame rail and there was an opening in the floor for access to fill the cylinder. I cannot say for sure exactly what the cover looked like since the opening was generally not on senior models because they rarely had manual brakes. It probably was just a round plate held by a couple of sheet metal screws.

You might see if there are any small holes around the edge of the opening that screws might thread into. If you find some then adding a bit more to that distance would give the approximate diameter of the plate.

Attach file:



jpg  (67.14 KB)
209_5f978d807af4f.jpg 718X966 px

This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=227521