Re: Dad's 5677A
Posted by Dads 56 On 2020/12/5 16:38:30
so I have the original 3 pole brake switch, the dark green wire is spliced to a yellow wire that leads to a switch and then the fuse block.
I found a post where a 2 prong switch can be used and a relay. that should be the way I should go now perhaps?
as a side note the white wire with the alligator clip goes to the light switch I think, I haven't quite figured out what that is about yet. have to be a contortionist to see up there....that I am not.
Attach file:
(154.70 KB)
(261.88 KB)
(341.34 KB)
(289.03 KB)
I found a post where a 2 prong switch can be used and a relay. that should be the way I should go now perhaps?
as a side note the white wire with the alligator clip goes to the light switch I think, I haven't quite figured out what that is about yet. have to be a contortionist to see up there....that I am not.
Attach file:
(154.70 KB)
(261.88 KB)
(341.34 KB)
(289.03 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=228587