Re: Cortes121's 1955 Clipper Custom

Posted by cortes121 On 2020/12/12 22:04:42

Don,

Thanks for letting me know, I'll give Classic Tube a call. One small snag, the brake line heading to the rear brakes might have been modified - I'm not 100% sure since I don't know the stock configuration - my line has a connector with a diversion to the Mico Lever Lock (hydraulic brake lock). Does anyone has a picture of the stock configuration of the brake line right below the driver side floor?

I cleaned up the tank a bit more this morning. I also removed the sending unit. Took a peek inside. Safe to say its pretty nasty. I also tested the sender with a multimeter and as expected the Ohms jump all over the place. I also don't see a float? Or is this how it is supposed to be? Either way I'll have to grab a ford one as I have seen others suggest (would love to know which one).

I also started on the driver's side door today. The Door refuse to close for some reason. Might have something to do with the 900 levels of rust coating all the components. I got the door panel off and now I'll study up on the door locks tonight.

Attach file:

---

  (492.22 KB)


  (357.36 KB)


  (251.69 KB)


  (121.27 KB)


  (218.30 KB)


  (231.68 KB)