Re: hph's 55 Clipper Project
Posted by humanpotatohybrid On 2024/4/22 13:21:44
Also, here is how I removed my vibration damper. First, remove the bolt and washer then screw the bolt back in about half way. Get a deep well 1-1/16 socket and, very important, fill it almost all the way up with washers. For me, 3/16 washers happened to have the right OD. Then just press with the C-clamps.
Eventually once it’s mostly out, flip the socket around and loosen the bolt to be only about 1/4 threaded. This will give the reach necessary. Even more than that and you can tap LIGHTLY with a dead blow on alternating sides to bump it out.
Attach file:
CE09505F-BC20-47E8-BD73-DD8CAA8EB785.jpeg (481.51 KB)
35372281-AACD-402A-B165-671470C067D1.jpeg (462.82 KB)
Eventually once it’s mostly out, flip the socket around and loosen the bolt to be only about 1/4 threaded. This will give the reach necessary. Even more than that and you can tap LIGHTLY with a dead blow on alternating sides to bump it out.
Attach file:
CE09505F-BC20-47E8-BD73-DD8CAA8EB785.jpeg (481.51 KB)
35372281-AACD-402A-B165-671470C067D1.jpeg (462.82 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=270597