I'm trying to figure out if my Distributor is bad enough to go for a full rebuild or not. The breaker plate should be free to move when the vac advance pulls on it, right? I can't budge anything in there, except the rotor a little bit against the advance springs. I've got a new vac pot on the way, but I think I may wind up pulling the Distributor and going through it. Mechanical advance is working from what I saw with a Timing gun, but vac advance was KO.
Thanks for any Feedback. Dizzy may go to AEM over the Winter, but that will cost a pretty penny if I decide to go that rout.
Attach file:
20221014_221354.jpg (396.51 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=249250