Re: PackardDon's 1956 Clipper Custom Sedan

Posted by Packard Don On 2021/12/13 20:26:54

It appears that I'll have some time tomorrow after all to work on the distributor as the insulation is done (yay!) and the two cars that the work displaced to the cold outdoors are back inside. Of course, everything else in the shop is still compressed into two-thirds of it so it's a bit tight moving around and I don't want to start re-organizing it all until the strand board has been put up in this last section while it's empty.

On the distributor, what holds the backing plate in once everything on it has been removed? I can move it about but it does not want to lift out as I expected it would.