Re: Packard shopping: Reyman

Posted by humanpotatohybrid On 2022/9/25 21:22:26

Thanks Howard I'll try to look for some replacement foam for the clips. I have plenty of light-density foam but IDK how well it would work, I'll need to experiment. And I think it might hold water too well and get moldy in not too long... I might pick up some door weatherstripping and try that.

Also would like to get some more #10 rubber washers for stuff like the "jet intake" studs.

Today:
- Got my better turn signal lenses installed into the housings. A very nice difference. (Keep in mind that both pairs were thoroughly cleaned!) Also, I have an NOS driver lens (not shown) and if it doesn't break the bank I'll pick up an NOS passenger to go with it.

- I ordered hardware for the rear armrests, turn signals, inside trim, etc. so I should have most or all of the missing hardware for the car. This week I plan on preparing the trim that goes around the turn signals, and the front grille. Whenever I pick up the rest of my Reynolds wrap I'll order pinstriping for it. I should be able to get most of the front trim on the car in short order a few weeks from now.