Today I got a couple dents out of one of the stainless steel trim pieces using just a 1x4 from an old pallet, and a 2# dead-blow hammer. The dents are still noticeable, but the apparent damage is greatly lessened.
Got some excess undercoating off some more trim with oven cleaner, but it didn't do anything for the original area that I was dealing with some posts below. I'll try again and leave it on for longer. Can recommends even 6 hours.
I vacuumed the rear seat bottom with my mini Shop Vac which made a noticeable difference, but it still needs cleaned properly. Plus other small things.
Photos: Before and after of both dents; "line" in the seat made just by vacuuming.
Attach file:
20220926_184556.jpg (195.37 KB)
20220926_185509.jpg (179.50 KB)
20220926_184606.jpg (157.87 KB)
20220926_185513.jpg (190.21 KB)
20220926_192441.jpg (312.05 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=248659