Re: hph

Posted by humanpotatohybrid On 2022/10/14 21:41:17
- Got a key made for the trunk lock I picked up so that's good to go now. (Photo 1.) At least for now I'm using the clip I pulled out of my Clipper a few days ago, derusted, and painted.

- As I mentioned before, the trim that pops into the trunk has little foam pieces presumably for waterproofing. I didn't have all the clips (11 total) so I used some new ones I bought, just with some packing foam. (Photo 2, 3.) Due to denting, the rear of the trim did not sit flush with the car so I used the one screw-on clip there. Instead of ordering tons of rubber washers off McMaster, I just bought some Gasket Rubber from the plumbing aisle of Home Depot so I can just just & drill/punch to size as I need it. (Photo 4.) Did I overthink it? Most likely, but that's the fun of it!

Anyway, nice to have another piece on the car. (Photo 5.)

- Also got the passenger side comb piece on and wired in. Boy are those a struggle!

Attach file:



jpg  20221014_141550.jpg (208.15 KB)
225076_634a1be71b910.jpg 1920X1440 px

jpg  20221014_134234.jpg (336.66 KB)
225076_634a1bfbafca6.jpg 1920X1440 px

jpg  20221014_135814.jpg (839.21 KB)
225076_634a1c0bc1fe6.jpg 1920X1440 px

jpg  20221014_140735.jpg (382.42 KB)
225076_634a1c18e2c8c.jpg 1920X1440 px

jpg  20221014_140835.jpg (452.58 KB)
225076_634a1c24b0698.jpg 1920X1440 px

This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=249279