Re: BigKev 1937 115-C Convertible Coupe

Posted by Bob J On 2022/11/22 8:55:48
I do not have a 115, but on my 120C there was an original wiring harness that is long gone as I made a new one. As to the routing I bet they are the same as the cowls look the same. The main part of the harness threads down the inside of the driver's cowl panel behind the kick panel, there should be a large support hook up on the door's upper hinge. It then goes through the body holes and comes out along the driver's side frame rail and into the engine compartment or the back down that rail to the tail lights and gas tank. I have the heavy wire for the horns and the ammeter, starter and voltage relay come out the centre hole on the firewall through a grommet. I have attached a picture but as I am still awaiting an engine to set in, the wire ends are still in a bit of disarray.
Bob J.

Attach file:



jpg  DSC02875.JPG (227.30 KB)
225215_637cd4191b392.jpg 1920X1440 px

This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=250487