Re: BigKev

Posted by Packard Don On 2022/11/24 16:59:47

Good job! I don't typically watch videos but one for this project was a must-see.

Until you mentioned it in an earlier post and again in the video, I hadn't noticed that the fenders had been extended and thought their appearance was due to the running board's flair being cut off. Once I did see it, I wondered if there might be a door clearance issue. I would keep the fenders as they are (maybe add something to the bottom to make it look more "finished") but check the hinge geometer to see if the door can open upward a little. It seems that tilting the lower hinge inward and changing the anchor point of the upper one while also shortening it would do the trick and keep the intended look.