Got the toe board modified enough so that it finally lays in. The shifter is for sure nearly 2" futher forward. So I had to remove the hump there. I also had to remove a section to clear that bump put on the Jag bellhousing.
Now just need to weld in some patches to close it all back in. Then I need to make that engine cover panel above. I made a few more changes after this picture as the engine was contacting the firewall in a few places. It is no longer.
Does anyone know what size bolts are used to secure the toeboard to the firewall? Half the bolts were missing when I got the car and for the life of me I can't find the where I put the two that were actually in there.
Thanks!
Attach file:
Screenshot_20221208_171549_Gallery.jpg (273.76 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=251325