Re: BigKev

Posted by BigKev On 2022/12/16 11:16:59

Ha! That is true!

There was one already in the body that on the passenger side interior has a square standoff on it (probably for a heater mount), and the slotted flathead faster that went through it was also being used on the engine side as well to clamp the temp sender tube in place. So I did remember to remove that nut and clamp first. But, the screw itself was rust welded in place and the factory 'nutsert" twisted out. So that will get replaced.

Those modern nutserts are very handy and easy to install when you need a blind nut. I bought a cheap kit from amazon that came with the install tool, several different mandrels, and an assortment of nutserts in different sizes.