Engine cover plate and toe board done and looking good. I used some insulation tape between the panels to seal them and reduce any rattle.
With all that looking good, it then got covered up with moisture/heat/sound barrier (aka generic dynamat).
The engine now has has at least an inch clearance between rear of it and the firewall.
With the dynamat in place, that pretty much hermetically seals off any panel gaps and existing holes in the firewall. This should greatly reduce heat and noise.
I'll fab up an a firewall pad with insulation and cardstock later.
Phew.
Attach file:
Screenshot_20221217_131723_Gallery.jpg (126.15 KB) Screenshot_20221217_132036_Gallery.jpg (163.94 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=251673