Re: BigKev
Posted by BigKev On 2022/12/19 19:40:29
Got all thr major sub-groups of wire harness pulled through into the engine and under the car via the original routing in the kick panel area.
It was much easier to loom everything as specific sub-harness (lights, engine, tail section, etc) and then sleeve those in loom and pull them through vs. having one massive harness that is pulled and then having to branch everything off.
I still need to finish pulling the tail section wiring all the way to the back. Currently it's pulled through and sitting under the car. All the engine bay wiring is in a flexible mesh type woven loom, but the tail section is in asphalt impregnated loom to protect it. It was a pain to pull all that wiring through it.
Attach file:
Screenshot_20221219_183006_Gallery.jpg (218.97 KB)
Screenshot_20221219_182909_Gallery.jpg (235.09 KB)
Screenshot_20221219_182843_Gallery.jpg (249.03 KB)
It was much easier to loom everything as specific sub-harness (lights, engine, tail section, etc) and then sleeve those in loom and pull them through vs. having one massive harness that is pulled and then having to branch everything off.
I still need to finish pulling the tail section wiring all the way to the back. Currently it's pulled through and sitting under the car. All the engine bay wiring is in a flexible mesh type woven loom, but the tail section is in asphalt impregnated loom to protect it. It was a pain to pull all that wiring through it.
Attach file:
Screenshot_20221219_183006_Gallery.jpg (218.97 KB)
Screenshot_20221219_182909_Gallery.jpg (235.09 KB)
Screenshot_20221219_182843_Gallery.jpg (249.03 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=251768