Re: BigKev
Posted by Bob J On 2023/2/8 15:04:52
Quote:
I faced the same thing, but found that discarding the bottom piece and running the new channel the entire length of the rear vent channel worked great. Door windows wind up and down smoothly with no gaps. There is an adjustment on the one arm of the window glass riser to dial in that feature to make them parallel to the front channel.
Bob J
Attach file:
Vent Frame rev.jpg (243.72 KB)
BigKev wrote:
Hmmm... beginning to wonder if there was an upper and lower run. I've seen that on other cars.
The factory plate shows that steel lower channel, unless I am looking at this incorrectly.
I faced the same thing, but found that discarding the bottom piece and running the new channel the entire length of the rear vent channel worked great. Door windows wind up and down smoothly with no gaps. There is an adjustment on the one arm of the window glass riser to dial in that feature to make them parallel to the front channel.
Bob J
Attach file:
Vent Frame rev.jpg (243.72 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=253699