Another project I got done was making kick panels for the car. The originals were long gone when I got the car. So I made these from paper templates. I make these from two layers, a 1/8" masonite and a 1/8" later of card stock. I did it this way so I could sandwich the panel clip heads between the layers so the head wouldn't show under the thin vinyl.
This is all temporary upholstery until I can get real upholstery done in the far future.
Once I had the masonite panels cut to shape. I used "dowel points" to transfer the hole locations from the metal structure to the new panel. Then drilled the 1/4" holes in the panel to accept the clips.
I used these panel clips I got from eBay. They hold the panel with good tension into the under-dash structure.
Attach file:
KickPanels.jpg (171.72 KB) PanelClips.jpg (152.68 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=257612