Re: BigKev's 1937 115-C Convertible Coupe

Posted by BigKev On 2023/10/29 11:50:08

Starting to swap the body sheet metal back to original fenders. I've already noticed an issue on the rear that will have to be addressed. The rear valance panel was replaced and it was made to fit the shape of the stretched rear fenders. So now it doesn't line up with the factory fender shape at the bottom corner. So that will have to get reworked in the future.

This replacement fender came from a sedan body, so it doesn't have the holes for the taillight. Can some with a junior coupe give a measurement from the back bottom edge of the fender to the center positon of the those holes? The custom fender have been reworked in that area so are no good for an accurate measurement.

Thanks!

Attach file:

---

  Screenshot_20231029_114318_Gallery.jpg (229.96 KB)