Re: BigKev's 1937 115-C Convertible Coupe

Posted by BigKev On 2024/3/24 18:50:42

Trying to figure out why the spacing between the roll up door windows and the convertible top swing up b-pillars is so tight. Tight to the point that stainless channel for the weather strip that mounts to pillar can't install without making contact with the window frame. There is no additional adjustment in the top mechanism. It's as far back as it can go.



I think it has to do with the position of the door window glass and possible the door window was either cut too large, of the setting tape they used is too thick. To confirm that I need the following measurements:

The space at top front of the glass, between the stainless edges.



And at the back bottom corner the gap between the stainless edge and the inside edge of the door window slot.



This will confirm if the door glass is sitting too far rearward and causing the issue I am seeing. Both these measurements are with the door window top dead even with the top of the vent window.

Thanks!