Re: 1937 120 Conv. Sedan - Blanche

Posted by TxGoat On 2024/5/2 13:47:09

The front fenders on my 120 do have a slight inboard curve at the bottom. Laying a straight edge along the running board shows a inward curve of about 5/8" to 3/4" measured just behind the front wheel opening. With the front fender to frame braces in place, the braces should locate the fender skirt accurately. The braces are straight. One of my braces is bent slightly, which pulls the bottom of the fender in very slightly, maybe 1/8". I believe the trim is made straight, and that it is flexible enough to conform to the slight inward curve of the lower fenders. My car does not have side mounts, but I think the fender contour and trim is the same. The curve amounts to 5/8" or a little more in the 2 feet or so of fender between the front of the running board and the wheel opening. Installing the trim with the fender skirt braces off, then installing the braces, should pull the fender into the proper place.