Re: 1936 Junior 120B
Posted by Ozstatman On 2009/12/7 15:11:20
Quote:Is this the clutch actuating bearing(the "throw-out" bearing)? If so it is attached to the snout on the front of the trans by one or two springs which need to be disconnected, an awkward job but doable, before the trans can be slid back.
Quote:Is that right? I think all the bellhousing bolts are on the external edge of the bellhousing, but then again I have been wrong on numerous occassions.
taxman wrote:.........A bearing on the very end of the shaft is frozen and will not budge (preventing us from pulling the tranny and shaft out). We are figuring on torching it to cut it so the tranny can be removed and I can replace the disc and pressure plate.......Has anyone had this problem, or is there something I am missing?
Quote:
taxman wrote:.........The bell housing bolts internally to the back of the engine......
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=42343