Re: Cigar lighter,Brians 51

Posted by HH56 On 2009/6/20 17:12:58

Here is readings I get from a 47 6 volt and a 56 12 volt. The values are approximate since at that low range, even the meter cables and probe connections can distort the reading. The black clip is on the metal outer edge and the red point is the center pin-(sorry about covering the 12v--it didn't want to co-operate). At any rate, yours should have some continuity between the center pin and the edge where element attaches. On both of these lighters, the center pin looks like it might have a slot which was crimped onto element and maybe a spot weld on the outer edge.

Attach file:

---

  (77.72 KB)