33-34. Slide the washer with the aligment holes into place. If a hole doesn't match with the button, you can either back the nut off slightly, or, in this case, torque it a little more to match the two pieces. It would depend on which way is closer.
35-36. If the cotter pin can fit through the key hole after the outer nut is placed, you know that the inner nut has been sufficiently torqued. Install a new cotter pin with the ends bent over the nut to keep it from backing off, then reinstall the cover, and you're done.
Attach file:
(54.15 KB)
(75.21 KB)
(46.93 KB)
(69.55 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=48692