Re: BigKev's 1954 Packard Clipper Deluxe Sedan
Posted by HH56 On 2017/2/10 12:02:45
I've been playing around a little with those too but you beat me to it. Here is what I made out of two different UV stabilized Urethanes --65a and 80a shore hardness. These were cast from a mold taken off the one good but petrified rubber piece which fits the ducts I have. No idea if the ducts are the same size as yours though. Think mine are ARA.
It will be good to compare how the hard plastic works vs the more flexible urethane. If the mass production type works that would be great. If you want these PM me an address and I will send them when the cure time is complete and rough edges can be trimmed a bit more.
Attach file:
(103.94 KB)
(71.01 KB)
It will be good to compare how the hard plastic works vs the more flexible urethane. If the mass production type works that would be great. If you want these PM me an address and I will send them when the cure time is complete and rough edges can be trimmed a bit more.
Attach file:
(103.94 KB)
(71.01 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=187918