Re: BigKev's 1954 Packard Clipper Deluxe Sedan
Posted by BigKev On 2017/9/3 15:22:29
I pretty much have the front pump, rear pump, and planetary assemblies squared away. Two questions:
If you look at the picture of below of the planetary bushing, the original bushing has an oil groove in it. The replacement bushing does not. Was this a change? or did I receive the wrong style bushing?
Another question on the rear pump gear, I failed to take a picture on disassembly, and I can't tell which way the small gear goes in.
Picture A shows the with the inner drive teeth level with the gear surface, picture B shows with inner drive teeth inset.
Looking at the service manual, it appears to be A (kinda grainy and hard to tell), but I can see where B made more sense the little piece that rides in there to set.
Attach file:
(75.71 KB)
(55.73 KB)
(96.26 KB)
(93.92 KB)
If you look at the picture of below of the planetary bushing, the original bushing has an oil groove in it. The replacement bushing does not. Was this a change? or did I receive the wrong style bushing?
Another question on the rear pump gear, I failed to take a picture on disassembly, and I can't tell which way the small gear goes in.
Picture A shows the with the inner drive teeth level with the gear surface, picture B shows with inner drive teeth inset.
Looking at the service manual, it appears to be A (kinda grainy and hard to tell), but I can see where B made more sense the little piece that rides in there to set.
Attach file:
(75.71 KB)
(55.73 KB)
(96.26 KB)
(93.92 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=195464