Well the parts I ordered from Kanter arrived today. So back in the garage after I got home from work. The outer seals that came with the real seal kit are just the seals and not the entire plate like the Max Merritt pictured version. So I pressed the new Kanter seals into my existing plates.
The drivers side axle came out pretty easy with a little tug from a slide hammer. I pulled the axle out and set it on top of the trash bin to keep from getting grease on anything. I then cleaned what was left of the bearing grease for the wearing. I am glad I pulled the axles to repack the bearing as the grease that was left was pretty much liquefied. I cleaned up the housing, and installed the the new inner seal. I then repacked the axle bearing and reinstalled the axle. It then was too dark to continue as the light on the passenger side of the garage is not as good.
I also finished painting the backing plates, drums, and also media blasted and painted the rear hardware. I need to source a new parking brake drum spring, as one side had a broken spring.
I also got the replacement water pump from Kanter. Time to send the old one back and recover my core charge.
Attach file:
(59.32 KB)
(41.17 KB)
(47.70 KB)
(53.08 KB)
(55.33 KB)
(49.24 KB)
(42.99 KB)
(48.07 KB)
(60.71 KB)
(46.68 KB)
(50.17 KB)
(62.99 KB)
(55.19 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=20952