Re: BigKev

Posted by BigKev On 2021/4/26 9:10:16

Yes, everything is on locking/swivel casters.

So I can roll that entire workshop out or move it around. I often roll that larger table/bench (6' x 3) over to where the daily drivers normally sit when working on larger projects. It's a great assemble table. Also, I can slide the blast cabinet to the right if I need to use it quickly.

The smaller table/benches are 2' x 4'. So I can put them together to create a 4' x 4' etc. Under the larger table is a rolling tool cart when I often roll out and use as an outfeed table for my table saw. My miter saw is on a HF tool cart with the top installed upside down to give me a flat surface. I can roll that into the middle of the space when cutting longer boards.

If I am using the table saw or miter, I usually roll them to the edge of the large garage door to help keep the dust down. Even with the shop vac and separator hooked up to the tool, they still spew dust.

This all goes back to having a flexible space that can change over time without having to rebuild everything.