Re: BigKev's 1954 Packard Clipper Deluxe Sedan

Posted by Marty or Marston On 2021/11/13 20:08:36

This is a process that I learned from a auto body repairman on my T-100 pickup that had wind noise on the upper front section of the door. I have since used it on my 2500 GMC pickup.

Open the door and place a short piece of 2 by 4 between the door and the pillar where the latch is just below where the bottom of the window is so the door won't close. Then push (in your case) the upper rear section of the door while using a knee to hold the bottom section of the door tight against the 2x4 so as to slightly push in the top section of the door. This may take a bit of force just take it in increments.