Re: BigKev's 1954 Packard Clipper Deluxe Sedan

Posted by BigKev On 2007/10/31 11:27:57

Randy, I believe you are correct about the floor pans.

They did arrive here at my office today. They are labeled 51-56 Packard (Made in U.S.A.).

While I have not yet held them up to my existing floor pans, they are different. I think it's a generic design the will fit any of the 51-56 Packards/Clippers, but they are not a reproduction of the factory stampings. They are a simplier design. Maybe this was done to make them more generic across any differences in the 51-56 Series/Models.

They may take a little working to get them to fit, but I think the overall bends and shape is about right.

I wont be able to tell until I try to lay them onto the exisitng pans.

Worst come to worst, they will make a good basis for patch panels.