Re: SpencerB's '54 Clipper Deluxe Sportster
Posted by Spencer On 2011/1/3 11:40:32
I've been delayed on the Packard for a while trying to get a friend's heli back to airworthy condition and moving my automotive shop as well. As a result, the engine build was postponed and I put the body on the frame for ease of transport.
I'm going to go with a different rear end than the camaro ten bolt I have because the tires would end up a little too far out for my liking. I may go with a first gen. camaro rear because it's 1.5"-2" narrower, but everything else in the drivetrain will still be third generation camaro down to the hyd. clutch.
By the way, if any of you guys are interested in my left over bits (toe board, btv, brake lines, fuel system, front brake assy's, rear axle, original wheels and so on) let me know. I'll help arrange shipping worldwide.
It's looking like a real car again! {sorta)
Attach file:
(29.15 KB)
I'm going to go with a different rear end than the camaro ten bolt I have because the tires would end up a little too far out for my liking. I may go with a first gen. camaro rear because it's 1.5"-2" narrower, but everything else in the drivetrain will still be third generation camaro down to the hyd. clutch.
By the way, if any of you guys are interested in my left over bits (toe board, btv, brake lines, fuel system, front brake assy's, rear axle, original wheels and so on) let me know. I'll help arrange shipping worldwide.
It's looking like a real car again! {sorta)
Attach file:
(29.15 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=67846