Re: Darrin's 1954 Super Clipper Club Sedan
Posted by Owen_Dyneto On 2010/12/5 23:55:40
Best suggestion I can offer is gentle persuasion. The one pictured below was a steel replacement from probably decades ago and we got it out with much trouble via use of long steel rods with hooks. Assuming yours is original it will be brass so it should be in one piece, probably held in by rust and salt formation. If you haven't opened up the engine yet, a couple of good hot soaks with oxalic acid might be adviseable before starting to disassemble.
Attach file:
(95.36 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=66025