I bought the slide hammer tool. It has no instructions. It has no pictures of the tool assembled. I gives no idea of which fixture is good for pulling an oil seal.
I searched the internet for a video on pulling the seal and what I found didn't use this tool. I don't want to damage the inside of my axle where the seal fits. One guy made a hook on the end of a bar and popped it out of a Toyota axle.
http://www.youtube.com/watch?v=qevb7w9pUdk Most of the videos show how to replace it, not remove it.
On this tool, the hooks swivel and don't stay hooked on the inside of the bearing.
I know I must be doing wrong. If it's obvious to you how this thing works, please reply. The hook in the picture is the one that doesn't swivel.
Attach file:
(46.93 KB) (102.77 KB) (82.66 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=138251