Re: The Duchess Project: 1940 Super 8 Convertible Sedan
Posted by Joe Santana On 2022/4/25 10:17:48
Thanks, Howard, this helps my understanding.
My pix are fuzzy, but you can see that the brass fitting looks a little thrashed. The shop may have added a copper washer to allow for more tightening and some flattening of the surfaces.
The taper on the old (maybe original) switch is barely perceptible. I'll check the dead NAPA switch when I take it out. I'm asking Kanter for the brass fitting.
Attach file:
NAPAswitch.jpg (79.93 KB)
switchtaper.jpg (79.18 KB)
My pix are fuzzy, but you can see that the brass fitting looks a little thrashed. The shop may have added a copper washer to allow for more tightening and some flattening of the surfaces.
The taper on the old (maybe original) switch is barely perceptible. I'll check the dead NAPA switch when I take it out. I'm asking Kanter for the brass fitting.
Attach file:
NAPAswitch.jpg (79.93 KB)
switchtaper.jpg (79.18 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=243087