Re: The Duchess Project: 1940 Super 8 Convertible Sedan
Posted by HH56 On 2022/4/25 14:32:23
Quote:
Joe Santana wrote:
To use the switch from Kanter, I would need a connector with a bullet on one end and female terminal on the other. The female end would slip over the male switch terminals and and the male end would plug into the two female wire terminals. .156 is what I'd look for. It could save rigmarole. Thanks.
I am not sure there is a ready made inline connector in anything other than the female to female configuration. You might need to use two individual terminals of the type you need and join them together with a short wire butting end to end on as a short extension cable.
When I used the yellow inlines, I covered them with black heat shrink and at a quick glance they appear as stock as the round Douglass connectors Packard had in some years. You could also cover a regular bullet with the heat shrink for a similar look to the thin black rubber sleeve Packard used on their terminals.
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=243094