Re: Henry's 55 Constellation
Posted by Cli55er On 2012/10/25 19:24:39
incase noone noticed...i missed the little wire that connects to the body of the distributor and then to the same screw that holds the vacuum advance arm to the plate.
i found it and attached it.
i need to know what to make the vacuum advance gasket out of. there is a pretty good size gap in the center of the vacuum advance when mocking fitting it and i don't think just paper gasket will do.
als, thanks to an old post by OD, i didn't know i needed a piece of felt under the rotor cap to lub the shaft. had no clue.
OD, since you hve the petronix, i am curious to see inside of yours. can you post me some pics so i can see. also are you running the petronix coil as well? if so how did you do the wiring since there is no need for a 1.5ohm resistor?
thanks,
Hank
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=111953