Re: Henry's 55 Constellation

Posted by Cli55er On 2008/1/25 15:27:33

yeah, that is what i asked of the guy from ultramatic dynamics.....how could the valve get too far forward unless by hand....it wasn't me. that was the way it looked when i droped the pan. i also noticed the screw that was holding the arm connected to the valve to the linkage was not what it says it is supposed to be in the manual. the manual describes a pin type system, but what was there was a screw and square bolt. the screw had a flat head screwdriver indent on it. didn't look factory.

i tried to tap on the bottom of the valve body itsef to see if it would come unstuck, but it didn't. i tried and tried to pull on the linkage that is connected to the valve, you can see i disconnected it from the rest of the linkage, but it will not budge. i guess i could try to tap it from the other end.

Bob aller thinks the tranny is froze....