Re: Henry's 55 Constellation
Posted by Eric Boyle On 2010/9/5 21:45:36
"turbo it was a small copper wire brush on a very slow setting with minimal pressure applied. then i came back with scotch brite and smoothed the bushing out so that i was semi-shinny again. i think that should be fine, wouldn't you?"
No, the whole thought of it scares the hell out of me. Honestly. I've heard of scraping babbitt with a knife to "adjust" clearance, but never any type of wire brush.
Since our German friend with the ability to always post an appropriate picture is no longer with us, I'll attempt to fill in:
Reminds me of a few other "not so good" ideas:
No, the whole thought of it scares the hell out of me. Honestly. I've heard of scraping babbitt with a knife to "adjust" clearance, but never any type of wire brush.
Since our German friend with the ability to always post an appropriate picture is no longer with us, I'll attempt to fill in:
Reminds me of a few other "not so good" ideas:
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=59383