Re: Kevin AZ's - 1955 Packard Senior Steering Wheel Restoration

Posted by Kevin AZ On 2012/6/3 21:12:08

Howard,

I not sure. I didn't have too much of an issue pushing/patting the epoxy into the fill holes. I used popsicle styled sticks and as seen in the pics didn't worry about over fill as I knew I'd be sanding the excess off. The consistency is of the stiffer variety but I liked that given the round shape of the wheel and because some of my applications were "upside-down".

BTW you can purchase PC 7 in a smaller amount ( two part tube) .

Hope this helps a little.