question on 3 speed munual trans

Posted by spfan On 2016/10/1 7:03:12

Hi Guys,
Looking for some ideas.I have a 1957 clipper sedan that is equipped with the borg-warner 3 speed with over drive.I recently had the original clutch replaced.It shifts great for about a half hour of driving time (aprox 7-10 miles) When I stop at a light I put it in neutral and take my foot off the clutch.When I press down the clutch and try to put it into first the gears chatter.If I take her home and start it up later she will run fine then repeat the whole situation again.The noise also happens at this time if I put her into reverse,second and third are fine. Any ideas?

Spfan